|Condition:||Original New||Warranty:||12 Months|
|Shipping Term:||DHL/TNT/UPS/FEDEX Etc.||Lead Time:||3-5 Days|
|Name:||Heavy Duty Limit Switch||Feature:||Durable|
precision limit switch,
enclosed limit switch
Ironman Technology Co.,LTD
● HONEYWELL ● AB ● OMRON ●SIEMENS ●SCHNEIDER
● ROSEMOUNT● ABB ● NOTIFIER ●MTL ● GE ●And many more !
Honeywell LSA2B Micro Switch 10 Amps Heavy Duty Limit Switch
Lead time:3-5 days
New with one year warranty
WIRING Use size #12AWG or smaller solid or stranded wire to connect to the pressure type connector terminals. Spades may be up to 0.312 inches wide, rings up to 0.312 inches dia. With spade or ring type connections, pre-insulated connectors or heat-shrinkable tubing should be used to provide insulation between terminals. The switch’s circuit diagram is shown on the nameplate. It is easier to wire the HDLS double-pole units by connecting lead wires to the terminals nearest the conduit opening first. A grounding screw is located in the housing near the conduit opening.
MICRO SWITCH™ HDLS switch units with an indicator light in the cover are furnished with lead wires from the light connected to the normally open male terminals (#3 and #4) unless otherwise specified. Wires can be unsoldered and reconnected to the normally closed male terminals or ordered connected to the normally closed terminals by using a modification code. Always connect these wires to the same set of terminals used for the load. Across the normally open male terminals (#3 and #4), the light will be on with switch not actuated. Across the normally closed terminals (#1 and #2) the light will be off.
Positioning the lever. The lever on rotary actuated units is adjustable through 360° around the shaft. Loosen the screw with a 9/64 inch hexagon key wrench, move lever to desired position, and securely tighten the screw until “teller tab” can no Ionger be moved by hand. Then tighten the screw another 1/8 to 1/4 turn to assure lever is tight on the shaft. Hexagon key wrenches are provided in adjusting tool set (part number LSZ4005). Adjustable Length Levers. A 9/64 hexagon key wrench is required to adjust length of adjustable levers. Top Roller Plunger. Position top roller plunger on desired roller plane by adjusting the head as explained in the Actuator Head section above.